RIDGID 1822-I Operator's Manual download pdf (Page 11)

Ridge Tool Company • Elyria, Ohio • U.S.A.

piece of 1

″ pipe with NPT threads at both ends and

a coupling.

Pipe Cut-Off with No. 364 Cutter (45 RPM)

(Figure 7)

1. With reamer and die head in their UP position

place No. 364 Cutter over pipe.

2. Turn carriage handwheel to line up cutter wheel to

cut-off mark. A convenient viewing angle is provided.

3. With control switch in the CLOSE (1) position step

on foot switch and tighten feedscrew handle.

4. Turn feedscrew handle until cut-off is completed.

5. Release foot switch, turn machine OFF and return

cutter to its up position.

Figure 7 – No. 364 Cutter

Pipe Reaming with No. 344 Reamer

(45 RPM)

(Figure 8)

1. With cutter and die head in their up position swing

reamer into its operating position.

2. With the control switch in the CLOSE (1) position

step on foot switch and feed carriage handwheel

towards the pipe.

3. With slight handwheel pressure feed reamer to

achieve desired ream.

4. Release foot switch, turn machine OFF and return

the reamer to its UP position.

1822-I Pipe and Bolt Threading Machine

Machine Operation Using

Standard Equipment

Before proceeding, read Safety Information section

thoroughly and familiarize yourself with basic machine

components. (Figure 6)

Check Oiling System

Remove chip pan and install 1 gallon of RIDGID

Thread Cutting Oil.

Electrical Power Source

Locate a power source as identified on the machine or

motor nameplate.

NOTE! Do not operate CSA approved machine if the

auxiliary fan does not run.

Automatic Pipe Chucking

WARNING

Never reach inside chuck cover while machine is

connected to a power source.

1. Measure and mark length of pipe to be worked.

2. Place transmission lever in 45 RPM position.

(Lever pointing to 3 o’clock position)

3. Swing all carriage tools into their UP position.

4. Run machine in OPEN (2) switch position to open

jaws.

5. Place the pipe in chuck with enough material

exposed to complete desired operation.

6. Place control switch in the CLOSE (1) position and

step on machine’s foot switch.

7. The RIDGID CENTER-LOCK Chuck will automat-

ically center and grip pipe or bolt.

Automatic Chucking Tips

1. Insert short lengths of pipe into chuck from front of

machine.

2. If pipe is chucked off center, run the machine in the

OPEN (2) switch position to release pipe and

rechuck. Slight off center chucking can be correct-

ed with a normal ream or cut-off operation.

3. Pipe or bar extending more than 4 feet beyond the

rear of the machine should be supported with a

pipe support.

Use RIDGID No. 46 Pipe Stand and E-1178X 12″

extension. An extension can be fabricated with a 12″

View Angle

Cutter

Handwheel

Feedscrew

Handle

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 70 71

Comments to this Manuals

No comments

RIDGID 1822-I Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Sewing machines RIDGID 1822-I