Ridgid micro EXPLORER User Manual download pdf (Page 21)

Figure 33 – Label on Battery

4. Select the appropriate location for the

charger before use. Check work area

for:

• Adequate lighting.

• Flammable liquids, vapors or dust

that may ignite. If present, do not work

in area until sources have been identi-

fied and corrected. The charger is not

explosion proof and can cause sparks.

• Clear, level, stable, dry place for

charger. Do not use the device in wet

or damp areas.

• Proper operating temperature range.

The charger and battery must both be

between 41°F (5°C) and 113°F (45°C)

for charging to begin. If the temperature

of either is outside of this range at any

point during charging, the operation will

be suspended until brought back to the

correct temperature range.

• Appropriate power source. Check to

see that the plug fits correctly into the

desired outlet.

• Sufficient ventilation area. The charg-

er needs a clearance of at least 4" (10

cm) on all sides to maintain a proper op-

erating temperature.

5. Plug cord into charger.

6. With dry hands, plug charger into the ap-

propriate power source.

microEXPLORER

™

Digital Inspection Camera

Ridge Tool Company

19

Charging Procedure/

Operating Instructions

WARNING

Always wear eye protection to protect

your eyes against dirt and other for-

eign objects.

Follow operating instructions to reduce

the risk of injury from electrical shock.

NOTE! New batteries reach their full capacity

after approximately 5 charging and dis-

charging cycles.

1. Set up charger according to the

Charger

Inspection and Set Up

section,

2. The charger conducts a 1-second life

test during which the LED blinks from

red to green. The charger then goes into

standby mode in which the LED is OFF.

3. With dry hands, insert the battery pack

onto the charger. The battery pack will

begin charging automatically. While the

battery is charging, the red LED will glow

solid.

4. When the battery is fully charged, the

green LED glows solid. The battery may

be removed and used.

• Once the battery is charged, it may re-

main on the charger until it is ready to

be used. There is no risk of over-charg-

ing the battery. When the battery has

been fully charged, the charger auto-

matically switches to retention charging.

5. With dry hands, unplug charger from out-

let once charging completes.

Cleaning Instructions

WARNING

Unplug charger before cleaning. Do not

use any water or chemicals to clean

charger or batteries to reduce the risk of

electrical shock.

1. If present, remove battery from charger.

2. Remove any dirt or grease from the exter-

ior of the charger and battery pack with a

cloth or soft non metallic brush.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 448 449

Comments to this Manuals

No comments