Ridgid micro EXPLORER User Manual download pdf (Page 9)

microEXPLORER

™

Digital Inspection Camera

Ridge Tool Company

7

Tool Inspection

WARNING

Daily before use, inspect your inspec-

tion camera and correct any problems

to reduce the risk of serious injury from

electric shock and other causes and

prevent tool damage.

1. Make sure the unit is OFF.

2. Remove the battery and inspect it for

signs of damage. Do not use the

microEXPLORER inspection camera if

the battery is damaged in any way.

3. Clean any oil, grease or dirt from the

equipment, especially the handles and

controls. This helps prevent the tool from

slipping from your grip.

4. Inspect the camera head lens for conden-

sation. To avoid damaging the unit, do not

use the camera if condensation forms

inside the lens. Let the water evaporate

before using again.

5. Inspect the full length of the cable for

cracks or damage. A damaged cable

could allow water to enter the unit and in-

crease the risk of electrical shock.

6. Check to make sure the connections be-

tween the handheld unit, extension ca-

bles and imager cable are tight. All con-

nections must be properly assembled for

the cable to be water resistant. Confirm

unit is properly assembled.

7. Check that the warning label is present,

firmly attached and readable. Do not op-

erate the microExplorer Digital inspec-

tion camera without the warning label.

Figure 9 – Warning Label

8. Check to make sure the expansion bay

door is fully closed.

9. With dry hands re-install the battery mak-

ing sure to properly close the battery

door.

10. Turn the power on

(Figure 8)

and make

sure the device cycles through the splash

screen and then displays the live screen.

Consult the troubleshooting section of

this manual if problems arise.

11. Turn camera OFF.

Tool and Work Area

Set-Up

WARNING

Set up the microEXPLORER inspection

camera and work area according to

these procedures to reduce the risk of in-

jury from electrical shock, entanglement,

and other causes and prevent tool and

system damage.

1. Check work area for:

• Adequate lighting.

• Flammable liquids, vapors or dust that

may ignite. If present, do not work in

area until sources have been identified

and corrected. The microEXPLORER

inspection camera is not explosion proof

and can cause sparks.

ON\OFF

Button

Port Cover

Figure 8 – ON/OFF Button

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 448 449

Comments to this Manuals

No comments