Ridgid micro EXPLORER User Manual download pdf (Page 20)

microEXPLORER

™

DigitalInspection Camera

Ridge Tool Company

18

• Do not insert the battery with cracked

case into charger. Damaged batteries

increase the risk of electrical shock.

• Never disassemble battery. There are

no user-serviceable parts inside the battery

pack. Disassembling batteries may cause

electrical shock or personal injury.

• Avoid contact with fluids oozing from

defective battery. Fluids may cause burns

or skin irritation. Thoroughly rinse with

water in case of accidental contact with

fluid. Consult doctor if fluid comes into

contact with eyes.

Description,

Specifications and

Standard Equipment

Description

The RIDGID Battery Charger (Catalog Num-

ber 30758), when used with appropriate bat-

tery packs (Catalog Number 30198) listed in

the Accessories section, is designed to charge

a 3.7V Lithium Ion RIDGID battery in approx-

imately 4-5 hours. This charger requires no ad-

justments.

Figure 31 – Battery and Charger

Battery & Charger

Specifications

Input............................100-240 VAC/

12 VDC 50/60Hz

Output.........................4.2V DC

Battery Type ...............3.7V Lithium Ion

Input Current

.................0.3A/1A (DC)

Weight ........................0.4 lbs (0.02 kg)

Dimensions:

Length .......................4.1" (10.4 cm)

Width .........................3.3" (8.4 cm)

Height ........................1.8" (4.6 cm)

Charge Time...............4-5 hours

Cooling.......................Passive Convention

Cooling (No Fan)

NOTE! This charger and batteries are not com-

patible with any of RIDGID Li-Ion Bat-

teries and chargers. See

Accessories

section for batteries compatible with

this charger.

Charger Inspection and

Set-Up

WARNING

Daily, before use, inspect the charger

and batteries and correct any problems.

Set up charger according to these proce-

dures to reduce the risk of injury from

electrical shock, fire, and other causes

and prevent tool and system damage.

1. Make sure the charger is unplugged.

Inspect the power cord, charger and bat-

tery for damage or modifications, or bro-

ken, worn, missing, misaligned or binding

parts. If any problems are found, do not

use charger until the parts have been

repaired or replaced.

2. Clean any oil, grease or dirt from the

equipment as described in the

Mainten-

ance

section, especially handles and

controls. This helps prevent the equip-

ment from slipping from your grip and

allows proper ventilation.

3. Check to see that all warning labels and

decals on the charger and battery are

intact and readable. The figures below

show the warning labels on the bottom of

the charger and the bottom of a battery.

Figure 32 – Label on Charger

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 448 449

Comments to this Manuals

No comments