RIDGID JP0600 Specifications download pdf (Page 18)

Assembly (continued)

Assemble Fence To Bed

1. Remove the two nuts and the washer from the bolt on

underside of the fence assembly.

2. Carefully lift the fence and place it onto the bed, lining

up the key slot in the fence with the key in the fence

support. The bolt will go through the slot in the fence

support.

3. Reinstall the washer and two nuts onto the toggle bolt.

4. Adjust the fence locking mechanism by tightening the

upper locking nut until only about 1/4 of a turn of the

fence lock knob is possible. Lock the fence in place.

Snug the lower nut up to the upper nut with an adjust-

able wrench. This will lock adjustment in place

Install Cutter Head Guard

1. Get the cutter head guard. Remove the pan head

screw from the bottom of the guard post.

2. Turn the spring-loaded knob 1 turn counterclockwise,

looking down through the hole in the infeed table.

3. Line the slot in the guard post with the pin in the knob.

Slide the post through table and over pin in the knob.

4. Reinstall the pan head screw in the bottom of the

guard post.

Cutter Head Guard Functional Check

WARNING: Cutter guard helps provide protection

over the cutterhead. It must always be in place and

functioning properly.

With the power off and the switch key removed, check the

guard to make sure it is functioning properly.

• Position the fence to the rear of the bed for maximum

width of cut. Do not position fence beyond rear edge of

cutter knives.

• Pass a 1/4 inch thick piece of wood over the cutterhead

between the guard and the fence.

The guard must return automatically to a “rest position”

against the fence when free of the wood.

If guard does not return automatically, adjust the guard

spring, as described in the next section.

Key Slot

Fence

Key

1/4 Turn

Support

Slot

Spring

Loaded

Knob

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments

RIDGID JP0600 Specifications Page 18

Comments to this Manuals

Related products and manuals for Unknown RIDGID JP0600