RIDGID JP0600 Specifications download pdf (Page 32)

Maintenance and Lubrication

Maintenance

Do not allow pitch to accumulate on the tables, the fence,

the cutter guard, the cutterhead or the knives. Clean

them with an appropriate solvent.

Apply a thin coat of paste type wax to the tables and the

fence so that the wood slides easily while feeding. This

also deters rusting.

Do not allow chips to accumulate on the underside of the

jointer/planer.

If power cord is worn, cut, or damaged in any way, have it

replaced immediately.

Disassembly of the motor should only be done by an

Authorized Service Center. Disregarding this may void

your tools warranty.

NOTE: The speed of this motor cannot be regulated or

changed.

Motors used on woodworking tools are particularly sus-

ceptible to the accumulation of sawdust and wood chips

and should be blown out or “vacuumed” frequently to pre-

vent interference with normal motor ventilation.

Lubrication

WARNING: Unplug the jointer/planer. Unit could

start suddenly. You could be badly hurt.

The ball bearings in this machine are packed with grease

at the factory. They required no further lubrication.

The following parts should be oiled occasionally with

SAE No. 20 or No. 30 engine oil.

1. Dovetail spacer and dovetail slide.

2. Elevation screw (first clean if necessary).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

No comments

RIDGID JP0600 Specifications Page 32