RIDGID WL1200 Owner's Manual download pdf (Page 9)

Holes Used for Mounting Boards and Wood Lathe to Leg Set

A - Board/Side Support

B - Board/Side Support

C - Plate Support/Board/End Support

D - Board/End Support

E - Headstock/Plate Support/Board

F - Bracket Plate/Plate Support/Board/Side Support

G - Belt Gaurd/Plate Support

H - Motor/Plate Support

J - Cord Clamps/Plate Support

K - Rear Foot/Board

Particle Board Table Top

Plate Support (Steel)

Carriage Bolt

M6x1.0-45

Flat Washer Nut Hex

6.5x19x1.6 M6x1.0

Lockwasher

6mm

Mounting Left Side Table Top

1. Find the following:

1 Particle Board Table Top

1 Plate Support (Steel)

2. From the loose parts package find the following:

4 M6 x 1.0-45 Carriage Bolts

4 M6x1.0HexHeadNuts

4 6.5 x 19 x 1.6 Flat Washers

4 6mm Lockwashers

3. Position the table top on the left side of the assembled

legset as shown

4. Front Side Stiffeners

Face the front of the legset and count over from the left

one slot and one hole. Place a carriage bolt through

the table top (hole A) and the side stiffener. Fasten in

place with a washer, lockwasher and nut. Finger

tighten only.

5. Rear Side Stiffener

Face the rear of the legset and count over from the

right two holes. Place a carriage bolt through the table

top (hole A) and the side stiffener. Fasten in place with

a washer, lockwasher and nut. Finger tighten only.

6. Locate the two holes marked C in the steel plate sup-

port. Place bolts;

- through these holes

- through the two holes marked C on the table top

- and through the holes marked C in the End Stiffener.

Place a washer, lockwasher and nut on these bolts.

Finger tighten only.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments

RIDGID WL1200 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Lathes RIDGID WL1200