RIDGID WL1200 Owner's Manual download pdf (Page 11)

Mounting Headstock

1. Find the following:

1 Belt Guard Assembly

1 Headstock Assembly

1 Plate Bracket

2. From the loose parts package find the following:

2 M6 x 1.0-65 Carriage Bolts

1 M6 x 1.0-45 Carriage Bolt

1 M6 x 1.0-12 Hex Head Screw

4M6x1.0HexNuts

4 6.5x19x1.6FlatWashers

4 6mm Lockwashers

4 M5 x 0.8-12 Pan Head Screws

4 5mm Lockwasher

3 M4 x 0.7-6 Screw

1Hex“L”Wrench4mm

3. Remove the headstock pulley using the 4mm hex “L”

wrench.

4. Find four pan head thread cutting screws and four

lockwashers from among the loose parts. Attach the

belt guard to the headstock assembly with these

screws and lockwashers. The arrows in this illustra-

tion show the location of the screws.

5. Locate the two holes on the left table top Labeled E

(from page 9). Position the headstock assembly so

the mounting holes line-up with the holes in the table

board. Place a M6 x 1.0-65 carriage bolt, through

these holes. Fasten in place with a washer, lock-

washer and nut.

6. Place the bracket plate next to the headstock as

shown. Attach the bracket plate to the back of the belt

guard assembly with a M6 x 1.0-12 screw, washer,

lockwasher and nut.

7. Locate Hole F on the left table board. Attach the

bracket plate to the table top through Hole F. Use an

M6 x 1.0-45 carriage bolt, washer, lockwasher and

nut. Finger tighten.

8. Locate the three holes Labeled G on the lower edge

of the belt guard plate. Place a M4 x 0.7-6 screw

through each of these holes and into the tapped

holes in the plate support.

9. Replace pulley on headstock tightening with 4mm

hex “L” wrench.

10. Securely tighten all nuts and bolts.

Pan Head Screw

M5x0.8x12

Belt Guard

Assembly

Bracket

Pan Screw

M4x0.7-6

Lockwasher

5mm

Hex Head Screw

M6 x 1.0-12

Hex “L” Wrench 4mm

Flat Washer

Nut Hex

6.5x19x1.6

M6x1.0

Carriage Bolt

M6x1.0-45

Carriage Bolt

M6 x 1.0-65

Headstock

Assembly

Lockwasher

6mm

Plate

M6x1.0-12

Hex Head Screw

M6x1.0-45

Carriage Bolt

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments

RIDGID WL1200 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Lathes RIDGID WL1200