RIDGID WL1200 Owner's Manual download pdf (Page 44)

Motor Connections

WARNING: For Your Own Safety, Turn Switch

"OFF" And Remove Plug From Power Source Outlet

Before Proceeding.

1. Open motor connector box cover located on right end

of motor (viewed from rear of motor) using a flat blade

screwdriver.

2. Remove green screw and lockwasher and insert

screw through round metal terminal on the end of the

green wire of power cord with lockwasher between

terminal and motor frame. (See illus.)

3. Reinsert green screw in the threaded hole. Tighten

securely.

4. Insert terminal end of white wire on spade terminal

marked T4 on the motor. Push terminal firmly until

seated.

5. Insert terminal end of black wire on spade terminal

marked T1 on the motor. Push terminal firmly until

seated.

6. Close motor connector box being sure that power

cord is seated in the largest strain relief groove, and

tighten box cover screws.

Terminal

Green Screw

Internal

Lockwasher

BlackWireto

Terminal T1

Green Wire to

Green Screw

Strain Relief

Groove

White Wire to

Terminal T4

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

No comments

RIDGID WL1200 Owner's Manual Page 44