RIDGID R4112 Use and Care Manual download pdf (Page 32)

22.5

31.6

22.5

33.9

22.5

Fig. 43

ADJUSTMENTS

DANGER:

Laser radiation. Avoid direct eye contact with light

source.

WARNING:

Use of controls or adjustments or performance of

procedures other than those specified herein can

result in hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figure 43.

 Set miter and bevel angles to 0º and lock in place.

 Use the work clamp to secure a piece of scrap wood.

 Plug the saw into the power source and make a slight

cut to score the wood.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the saw arm.

 Using a padlock, lock the switch trigger to make the saw

inoperable.

 Turn on the laser guide.

 Rotate laser adjustment screw #1 (yaw adjustment)

clockwise or counter clockwise until the laser is parallel

with the cut in the wood.

 Rotate laser adjustment screw #3 (lateral adjustment)

until the laser line is parallel against the left edge of the

score line.

 Move the saw arm up and down, and inspect the laser

line position. If the laser line drifts out of position as the

saw arm moves, lift the saw arm to its full height, and

rotate laser adjustment screw #2 (tilt adjustment) left or

right until the laser no longer moves.

NOTE: The laser should remain parallel against the left

edge of the kerf of the blade during the full movement of

the saw arm.

 Repeat the steps above until the laser is properly aligned.

NOTE: If laser does not align correctly, return to your nearest

Authorized Service Center for repair.

LASER

ADJUSTMENT

SCREW #1

LASER

ADJUSTMENT

SCREW #2

LASER

ADJUSTMENT

SCREW #3

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 111 112

Comments to this Manuals

No comments

RIDGID R4112 Use and Care Manual Page 32

Comments to this Manuals

Related products and manuals for Power tools RIDGID R4112