RIDGID Dry Cut Saw Operator's Manual download pdf (Page 9)

Ridge Tool Company • Elyria, Ohio • U.S.A.

Securing the Workpiece with Lever Vise

• Raise the upper lever to release the feed mecha-

nism.

(Figure 8)

• Push the horizontal lever (feed or fence bar) until

the vise contacts the pipe.

(Figure 8)

• Bring the upper lever to the horizontal position.

The workpiece is now securely tightened.

NOTE! Always use both hands when using the vise to

prevent saw from tipping.

NOTE! For smoother operation and extended life, keep

the vise mechanism lubricated.

Figure 8

SAVE THESE INSTRUCTIONS!

WARNING

Always be sure that the tool is switched OFF and

unplugged before changing blade or servicing saw.

Make sure the blade hex bolt is securely tightened.

IMPORTANT! The RIDGID Dry Cut Saw blade will give

long life if certain elemental rules are fol-

lowed:

• Do not force the blade into the material

to be cut.

• Only cut material within the specified

capacity for the saw blade.

• Let the machine reach full speed before

starting to cut.

• NEVER stop and restart with the blade

in contact with the material. This will

break the teeth.

• Clamp the material correctly and ensure

that it is centered relative to the blade.

(Figure 9)

Maintenance

Replacing Carbon Brushes

1. Replace carbon brushes when they wear down to

about

″ (6 mm) or sparking will occur. Both brush-

es should be changed at the same time.

(Figure 10)

2. Use the slotted (—) screw driver to remove the

brush caps.

(Figure 11)

3. Take out the worn brushes inside, put in the new

ones and replace the caps.

614 Dry Cut Saw

Figure 9

Figure 10

Figure 11

Horizontal

Lever

Upper Lever

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Comments to this Manuals

No comments

RIDGID Dry Cut Saw Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools RIDGID Dry Cut Saw