RIDGID Dry Cut Saw Operator's Manual download pdf (Page 6)

Dry Cutter Safety

1. Keep all guards in place and in working order.

Damaged guards increase risk of injury.

2. Always clamp the workpiece with vise. Prevent

loss of control of the workpiece.

3. Workpiece must be cut-off against the direction

of the saw only. Prevents workpiece from being

thrown.

4. Be sure cut-off saw is sharp and free from

vibration. Less likely to bind and lose control.

5. Raise the cut-off saw from the kerf of the work-

piece prior to releasing the trigger switch. Less

likely for saw blade to bind.

6. Allow motor to reach full speed before cutting.

Prevents stalling of motor.

7. Use only cut-off saw blade with speed rating at

least as high as the RPM specified on the

nameplate. Improper blade may be hazardous and

result in injury.

Ridge Tool Company • Elyria, Ohio • U.S.A.

8. Don’t place either hand in the working area

when tool is connected to receptacle. Increases

the risk of injury.

9. Never clamp or tie guard in the open position.

Exposed blade increases the risk of injury.

10. Use proper extension cord. When using an

extension cord of 25 ft. or less use a 14 AWG cord,

for cords up to 50 ft. use a 12 AWG cord. Use of

cords over 50 ft. is not recommended. Use of any

other extension cord will result in deterioration of

tool performance.

SAVE THESE INSTRUCTIONS!

Description, Specifications and

Standard Equipment

Description

This saw has been designed to cut several materials

and geometric configurations, including:

1. Lining tube, gas pipe, electrical wire pipe, steel

pipe, PVC pipe & all kinds of metal pipe.

2. Angle steel, channel steel, steel bar & bolt.

3. Aluminum frame, curtain rail & all kinds of interior

decoration material.

Capacity

Standard Equipment

• Dry Cut Saw

•14″ Blade (Installed)

• Two (2) Allen Wrenches

614 Dry Cut Saw

Blade Size No Load Speed Voltage Hz Ampere Net Weight Power Supply Cord

14″ x .087″ x 1″ 1300RPM 115V 50-60 Hz 15A 49 lbs. 8.2 ft. (2.5M)

Specifications

▲ WARNING

Fingers, hands, arms or other body parts can be

cut.

• Wear safety glasses and ear protection.

• Keep hands out of path of saw blade.

• Do not operate saw without guards in place.

• Do not perform any operation freehand.

• Never reach around saw blade (or never reach in

back of saw blade.

• Switch tool off and unplug power cord from recep-

tacle before servicing or adjusting the saw.

READ ABOVE WARNING CAREFULLY!

Model 614 Capacity Chart

Cutting Workpiece Geometry

Angle

90˚ Cuts 5″ 3-3/4″ x 7″ 4-1/2″ x 4-1/2″

130mm 95mm x 180mm 115mm x 115mm

45˚ Cuts 4″ 3-1/2″ x 4″ 3-1/2″ x 3-1/2″

100mm 90mm x 100mm 90mm x 90mm

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Comments to this Manuals

No comments

RIDGID Dry Cut Saw Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools RIDGID Dry Cut Saw