RIDGID RP 330-B Operator's Manual download pdf (Page 7)

NOTE! RIDGID jaw sets are offered in two “series”

• Standard Series

• Compact Series

These jaw sets are not interchangeable. That is,

only standard series jaw sets will work with

standard series tools (RP 330, 320-E, CT-400).

Similarly, only compact series jaw sets will work

with the Compact 100-B Pressing Tool. Please

refer to the compact tool’s operator's manuals

for further information on these tools and jaws.

Selection of appropriate materials and joining

methods is the responsibility of the system designer

and/or installer. Before any installation is attempted, care-

ful evaluation of the specific service environment, includ-

ing chemical environment and service temperature, should

be completed. Consult Press Fitting System manufactur-

er for selection information.

Tool Inspection

WARNING

Daily before use, inspect your pressing tool and

correct any problems to reduce the risk of serious

injury from electric shock, crushing injures, attach-

ment failure and other causes, and prevent tool

damage.

1. Make sure that the pressing tool is unplugged or the

battery is removed. If a corded tool, inspect the power

cord and plug for damage or modifications. If a battery

tool, inspect the battery for damage. If any damage or

modifications are found, do not use the tool until the

cord or battery has been properly repaired or re-

placed.

2. Clean any oil, grease or dirt from the equipment,

especially the handles and controls. This helps to

prevent the machine or controls from slipping from

your grip.

3. Inspect the pressing tool for any broken, worn, miss-

ing, mis-aligned or binding parts or any other condition

which may prevent safe and normal operation. Make

sure that the attachment mounting pin moves smooth-

ly between the fully open and full closed position

and locks into each. Confirm that the switch moves

freely and does not bind or stick. If any problems

are found, do not use machine until problems have

been repaired.

cate problems such as improper temperature, open jaw

mounting pin or maintenance required.

Figure 1 – RP 330 Pressing Tool and Standard Series Jaw

Set

Specifications

RP 330-C Corded Pressing Tool:

Motor

Voltage ...................120V, Single Phase AC 60 Hz

Amperage ...............5 Amp

Power .....................520 Watts

Weight........................9.00 lbs. (4.1 Kg)

Ram Force .................7,200 lbs. (32kN)

Operating Temperature

Range ...........................15° F to 122° F (-10° C to 50° C)

Duty Cycle...................1 Crimp /min.

RP 330-B Battery Pressing Tool:

Motor

Voltage ...................18V DC

Amperage ...............27.2 Amp

Power .....................490 Watts

Weight........................8.4 lbs. (3.8 Kg)

Ram Force .................7,200 lbs. (32kN)

Operating Temperature

Range ...........................15° F to 122° F (-10° C to 50° C)

Duty Cycle...................1 Crimp /min.

NOTE! The RP 330 Pressing Tool and Standard Jaw

Sets are protected under various U.S. and inter-

national patents and patent applications.

Ridge Tool Company 5

RP 330 Pressing Tool

LED Display

Panel (Rear)

Scissor Style

Jaw Set

Jaw Arm

Attachment

Mounting Pin

Battery

Tool Housing

Switch

Handle

Jaw

Sideplate

NOTICE

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

RIDGID RP 330-B Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools RIDGID RP 330-B