RIDGID RP 330-B Operator's Manual download pdf (Page 12)

ature within the operating range by placing it in a condi-

tioned room for several minutes before use. This will be

indicated by a red glowing LED on the display panel.

Store the carrying case in a dry, secured,

locked area that is out of reach of children and people

unfamiliar with the RP 330 Pressing Tool. The tool is

dangerous in the hands of untrained users.

Ridge Tool Company10

RP 330 Pressing Tool

RP 330 Pressing Tools

Cleaning and Lubrication

1. Daily wipe the tool clean with a clean dry cloth.

2. Inspect the attachment mounting pin and lubricate the

pin with silicone lubricant as needed.

3. Check return springs in attachments with each use.

Attachments should open and close freely with only

moderate finger effort required.

Required Maintenance at RIDGID

Authorized Service Center

After 30,000 cycles, the tool will show a blinking yellow

LED on the display panel as long as the tool is turned on

to indicate that it is time for maintenance and recalibration.

The tool will not run if it is not maintained within 2,000

more cycles after the yellow blinking LED begins.

Accessories

WARNING

Only the following tool accessories have been de-

signed to function with the RP 330 Pressing Tools.

Other accessories suitable for use with other tools

may become hazardous when used on the RP 330.

To prevent serious injury, use only the accessories

specifically designed and recommended for use

with the RP 330, such as those listed below.

dge Tool Company provides Standard Pressing

attachments designed specifically for use with

RIDGID Standard Pressing tools. Only use attach-

ments that are specifically designed to press the fit-

ting system you are installing. For a complete listing

of RIDGID attachments available for this tool, see

the Ridge Tool Catalog.

Storage

Place the tool and jaws in its carrying case. Avoid storing

the tool, batteries or charger in extreme heat or cold.

The tool temperature sensor will not allow the tool to

turn on if oil temperature is not within the temperature

range of 15°F (-10°C) to 122°F (50°C). So it may be

necessary to allow the tool to warm or cool to a temper-

WARNING

Catalog

No. Description

27968 18V Lithium-Ion Battery Pack 2.2Ah

27958 115V Charger

27933 Carrying Case (Plastic)

RP 330 Press Tool Accessories

1 2 ... 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

RIDGID RP 330-B Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Power tools RIDGID RP 330-B