RIDGID 1822-I Operator's Manual download pdf (Page 22)

Ridge Tool Company

Figure 23A – Remove Jaw Insert

Figure 23B – Remove Jaw Insert

5. Reinstall jaw insert and finger, and tighten screw.

Rear Centering Finger/Jaw Replacement

1. With rear centering jaw in the OPEN position unplug

machine and remove rear cover.

2. Remove three e-clips holding rear retainer in place

and remove retainer. (Refer to Figure 26 Step 1.)

3. Remove spacers and rear centering jaws.

4. On a workbench, drive out pins holding centering

finger in place and install new centering finger.

5. Reinstall rear jaws and spacers on rods. (Refer to

Figure 24.) Locate square pin in jaw slot.

Figure 24 – Reinstall Rear Jaws and Spacers on Rods

6. Reinstall rear retainer and retaining clips.

Spindle Conversion Kit for

Plastic Coated Pipe

Figure 25 – PCP Kit

Spindle Assembly Removal

1. With machine OFF and unplugged, remove front and

top covers.

2. Remove rear centering assembly.

3. Remove three (3) brake shoes. (Refer to Figure 26.)

4. Remove small E-clips and washers holding front jaws

to drive sprocket. Slide out spindle assembly.

Spindle Assembly Installation

1. Following reverse procedure, install new spindle as-

sembly for plastic coated pipe.

1822-I Pipe and Bolt Threading Machine

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 78 79

No comments

RIDGID 1822-I Operator's Manual Page 22