RIDGID 1822-I Operator's Manual download pdf (Page 16)

SeeSnake

microDrain™ Inspection System

Camera video image not

seen.

SOS blinking on LCD.

(Some SeeSnake CCUs.)

No power to SeeSnake CCU or microEXPLORER

Camera monitor connector.

Connections faulty.

Monitor set to wrong source.

Batteries Low.

No video signal.

Check power is correctly plugged in.

Check switch on monitor/display unit.

Check alignment and pins of connection to

microDrain System unit from camera control or

display unit.

Check orientation, seating, and pin condition in the

SeeSnake connection.

Set video source as described in display unit

manual.

Recharge or replace batteries.

Check source setting of monitor and re-seat cable

connection.

PROBLEM PROBABLE FAULT LOCATION SOLUTION

Chart 1 Troubleshooting

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

1 2 ... 11 12 13 14 15 16

No comments

RIDGID 1822-I Operator's Manual Page 16