RIDGID 1822-I Operator's Manual download pdf (Page 11)

2. Set the microDrain Reel approximately six feet (two

meters) from the entry point. This provides ample

pushrod for grasping and manipulating without excess

dragging on the ground. When properly located, push

cable will only come off the reel when you pull it.

Preferably, lay the microDrain Reel on its back with

the camera unit and pushrod on top. There are foot

pads provided on the cord wrap to allow placement

in this position. This position provides the greatest

stability and helps to prevent tipping of the reel dur-

ing use.

Operating Instructions

WARNING

Always wear eye protection to protect your eyes

against dirt and other foreign objects.

When inspecting drains that might contain haz-

ardous chemicals or bacteria, wear appropriate

protective equipment, such as latex gloves, goggles,

face shields or respirators, to prevent burns and in-

fections.

Do not operate this equipment if operator or ma-

chine is standing in water. Operating machine while

in water increases the risk of electrical shock.

Rubber soled, non-slip shoes can help prevent slip-

ping and electric shock, especially on wet sur-

faces.

Follow operating instructions to reduce the risk of

injury from electrical shock and other causes.

1. Make sure all equipment is properly set up.

2. Pull several feet of pushrod from the reel. Make sure

the camera window is clean. In some cases, a slight

film of detergent on the window may minimize debris

sticking to the window. Place the camera unit into the

line to be inspected.

If running the camera through a porcelain

fixture (such as a toilet) or in an inlet with sharp

edges that could damage the pushrod, you may

want to use a guide made of PVC or other non mark-

ing pipe to prevent damage to the fixture or the

pushrod.

See section “Using Guide Tubes”

3. Turn the CCU on. As per the specific CCU operator

manual, adjust the camera head LED lighting bright-

ness and the display image. As the pipe material

and other factors vary, it may be necessary to make

Ridge Tool Company

SeeSnake

microDrain™ Inspection System

outer locking sleeve on the cable connector to retain the

system cable in place. Do not twist the cable while

tightening the locking sleeve. This can damage the

cable.

See Figure 13 and 14.

Figure 13 – Connecting To A SeeSnake CCU

Figure 14 – microDrain System Connected to

SeeSnake

MINIPak Monitor CCU

If using a microDrain System set up for use with a

microEXPLORER Camera monitor, it can be converted

for use with other SeeSnake CCU’s (or vice versa) by

changing the system cable as detailed in the assembly

section.

Set up the microEXPLORER Camera monitor or CCU as

per its instructions. If using the microEXPLORER Camera

monitor or a battery powered CCU, make sure that the re-

quired batteries are fully charged and installed.

Placement

1. Place the microEXPLORER Camera monitor or CCU

monitor to allow easy viewing while manipulating the

pushrod and camera. Usually right next to the entry

point for the pushrod is a good choice. The location

should not be wet or allow the monitor unit to get wet

during use.

NOTICE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

RIDGID 1822-I Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Sewing machines RIDGID 1822-I