Ridgid SeekTech SR-20 User Manual download pdf (Page 4)

Ridge Tool Company

Tools For The Professional

seekTech sR-20

Introduction to the SR-20

Getting Started

Installing/Changing Batteries

Figure 2: Battery Case

CAUTION: Do not allow debris or moisture into battery

compartment. Debris or moisture may short the battery

contacts, leading to rapid discharge of the batteries, which

could result in electrolyte leakage or risk of re.

Folding Mast

IMPORTANT! Do not snap or whip the SR-20 mast to open or

close it. Open it and close it by hand only.

NOTE: Avoid dragging the lower antenna node on the

ground while locating with the SR-20. It may cause signal

noise which will interfere with results, and may eventually

damage the antenna.

Figure 3: Folding Antenna Mast and Release Button

SR-20 Modes

The SR-20 operates in three distinct modes. They are:

1. Active Line Trace Mode, used when a chosen

frequency can be put onto a long conductor using a

Line Transmitter, for locating conductive pipes, lines,

or cables.

Passive Trace Mode, used for tracing electrical lines

that are already carrying 60 Hz current (U.S.), 50 Hz

current (Europe), or radio frequencies.

Sonde Mode, used for locating Sondes in pipes,

conduits, or tunnels that are non-conductive or

cannot otherwise be traced.

Release Button

1 2 3 4 5 6 7 8 9 ... 300 301

No comments

Ridgid SeekTech SR-20 User Manual Page 4