RIDGID MS1065LZ Service Manual download pdf (Page 19)

--- 16 ---

(1) Setting to cut crown molding at positions and in Fig. 14 (See Fig. 15, tilt the head to the left.):

Turn the turn table to the right and set the miter angle as follows:

For 45û type crown moldings: 35.3û ( mark)

For 38û type crown moldings: 31.6û ( mark)

Turn the head to the left and set the bevel angle as follows:

For 45û type crown moldings: 30û ( mark)

For 38û type crown moldings: 33.9û ( mark)

Position the crown molding so that the lower surface ( in Fig. 13) contacts the fence as indicated in

Fig. 17.

3 A

Head

Miter angle scale

Bevel angle scale

Fig. 15

(2) Setting to cut crown moldings at positions and in Fig. 14 (See Fig. 16, tilt the head to the left.):

Turn the turn table to the left and set the miter angle as follows:

For 45û type crown moldings: 35.3û ( mark)

For 38û type crown moldings: 31.6û ( mark)

Tilt the head to the left and set the bevel angle as follows:

For 45û type crown moldings: 30û ( mark)

For 38û type crown moldings: 33.9û ( mark)

Position the crown molding so that the lower surface ( in Fig. 13) contacts the fence as indicated in

Fig. 18.

2 3

Fig. 16

Bevel angle scale

Turn table

Fence

Miter angle scale

Fig. 17

Fig. 18

Fence

Table on base

Fence

Table on base

Base

Turn table

Base

Fence

Head

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 66 67

No comments

RIDGID MS1065LZ Service Manual Page 19