RIDGID MS1065LZ Service Manual download pdf (Page 48)

--- 45 ---

a Improper wiring

b Switch (A) failure

c Switching power

supply failure

d Laser holder failure

a Switching power

supply failure

b Laser module failure

a Ink line is not right

angle.

b Laser marker accuracy

is not adjusted

properly.

c Product accuracy is

not good.

a Laser marker is

horizontally deviated

from the saw blade.

b Laser marker accuracy

is not adjusted

properly.

6 Laser marker does not

light.

(Only the Model C 10FCH2)

------

------

------

------

------

------

------

0.2/100

(Figs. 52 and 53)

------

------

• Check the wiring.

• Check the Switch (W/Cover)

[165] for conductivity.

• Replace the Switch (W/Cover)

[165].

• Check the Switching Power

Supply [157] for conductivity,

input and output referring to

"11-4. Wiring Diagram."

• Replace the Switching Power

Supply [157].

• Replace the Laser Holder [1].

• Same as item 8-(c).

• Same as item 8-(d).

• Make a correct ink line again.

• Readjust the accuracy of the

laser marker. (Refer to "11-9.

Adjustment of Laser Marker

Accuracy".)

• Readjust the accuracy of the

product and the laser marker.

• Adjust the position of the laser

line. (Refer to "8-1. Position

Adjustment of Laser Line.")

• Same as item 10-(b).

Item

Phenomenon

Cause

Factory

standard

Inspection, repair or

adjustment

8

Laser line does not

match the ink line.

(Only the Model C 10FCH2)

9

Laser line does not

match the cutting

position.

(Only the Model C 10FCH2)

7

Laser light is poor or

strong.

(Only the Model C 10FCH2)

Laser beam

Laser emitting

aperture

Squareness

0.2/100

Fig. 52

Laser beam

Laser emitting

aperture

Squareness

0.2/100

Fig. 53

Squareness

0.2/100

Fence (B)

Fence (A)

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 66 67

Comments to this Manuals

No comments