RIDGID MS1065LZ Service Manual download pdf (Page 18)

--- 15 ---

For miter cut setting

If the turn table has been set to either of the angles described, move the turn table adjusting side handle a

little to the right and left to stabilize the position and to properly align the miter scale and the tip of the

indicator before the operation starts.

For bevel cut setting

Move handle on miter section to the right and left and check that the position is stable and the angle scale

and the tip of the indicator are properly aligned. Then tighten the clamp lever.

(8) Crown molding cutting

This machine can cut two types of crown molding workpieces by combining the miter and bevel cutting

operations (for USA).

Figure 13 shows two common crown molding types having angles of (θ) 38û and 45û. For the typical crown

molding fittings, see Fig. 14.

(7) Compound (miter + bevel) cutting

Compound cutting can be accomplished by combining the miter cutting and bevel cutting operations described

in paragraphs (4) and (5) above. (For details, please refer to the Instruction Manual.) When the saw blade

section (head) is inclined 45û to the left, the table can be turned up to 45û to the right and left.

The table below shows the miter angle and the bevel angle settings that are ideal for the two crown molding

types.

NOTE: For convenience, positive stops are provided for both the miter setting and the bevel setting

(left and right 31.6û) positions.

Type of

crown molding

To process crown molding at

positions and in Fig. 14

To process crown molding at

positions and in Fig. 14

Miter angle

setting

Bevel angle

setting

Miter angle

setting

Bevel angle

setting

Right 30û

( mark)

Right 35.3û

( mark)

Left 30û

( mark)

Right 30û

( mark)

Left 35.3û

( mark)

Left 30û

( mark)

45û type

Right 31.6û

( mark)

Left 33.9û

( mark)

Right 33.9û

( mark)

Left 31.6û

( mark)

Left 33.9û

( mark)

38û type

1 4

Right 33.9û

( mark)

Table 3

Upper surface ceiling

Wall

Lower surface

Fig. 13 Fig. 14

Outside corner

Ceiling

Wall

Inside corner

θû

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 66 67

Comments to this Manuals

No comments

RIDGID MS1065LZ Service Manual Page 18

Comments to this Manuals

Related products and manuals for Circular saws RIDGID MS1065LZ