Ridgid FINISH STAPLER R150FSA User Manual download pdf (Page 11)

Fig. 2

OPERATION

WARNING:

Always wear eye protection. Eye protection does

not fit all operators in the same way. Make sure the

eye protection chosen has side shields or provides

protection from flying debris both from the front

and sides.

NO-MAR PAD

See Figure 2.

The no-mar pad attached to the nose of the tool helps

prevent marring and denting when working with softer

woods.

WARNING:

Disconnect the tool from the air supply before

removing or replacing the no-mar pad. Failure to

do so could result in serious personal injury.

The pad can be removed by pulling it down and away from

the nose. To replace the pad, fit it into place over the nose

and push up to reseat.

On-board storage for the pad is located on the magazine of

the tool. An extra no-mar pad is provided in the on-board

storage area.

ADJUSTING THE EXHAUST

See Figure 3.

The adjustable exhaust on the end cap of the tool allows the

operator to direct the exhaust according to operator prefer-

ence. To adjust, turn the exhaust cap until the exhaust blows

in the desired direction.

Fig. 3

NOSE

NO-MAR PAD

ADJUSTABLE

EXHAUST

NO-MAR PAD

STORAGE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Ridgid FINISH STAPLER R150FSA User Manual Page 11