RIDGID OF45150 Operator's Manual download pdf (Page 7)

1. Read instructions: Carefully read

through this owner’s manual

BEFORE OPERATING the new air

compressor. It contains information

about operation and maintenance of

unit.

2. Drain tank daily: Depressurize system

prior to draining tank. Open tank

drain valve and drain moisture from

tank. This helps prevent tank corro-

sion and keeps oil and moisture out

of the compressed air system. Be

sure to close tank drain valve tightly

before operating compressor.

3. Change air filter: Never run compres-

sor without an air filter nor with a

clogged air filter. Replace with a new

filter when the element is dirty.

Operating Your Air Compressor

13

Getting to Know Your Air

Compressor (Continued)

12

3. Regulator Knob

1. This knob controls air pressure to an

air operated tool or paint spray gun.

2. Turning knob clockwise increases air

pressure at outlet.

3. Turning counterclockwise will lower air

pressure at outlet.

4. Fully counterclockwise will shut off flow

of air completely.

4. Air Filter

The air filter keeps dirt and debris from

entering the compressor pump.

ASME Safety Valve

1. This valve automatically releases air if

air receiver pressure exceeds preset

maximum.

2. This valve should be checked occa-

sionally by pulling the ring by hand. If

air leaks after ring has been released,

or valve is stuck and cannot be actuat-

ed by ring, it MUST be replaced.

Do not attempt to tamper with

this valve!

!

DANGER

Close

Open

Attach

Hose

Moisture in compressed air will form into

droplets as it comes from an air com-

pressor pump. When humidity is high or

when a compressor is in continuous use

for an extended period of time, this mois-

ture will collect in the tank. When using a

paint spray or sandblast gun, this water

will be carried from the tank through the

hose, and out of the gun as droplets

mixed with the spray material.

IMPORTANT: This condensation will

cause water spots in a paint job, espe-

cially when spraying other than water

based paints. If sandblasting, it will

cause the sand to cake and clog the gun,

rendering it ineffective.

A filter in the air line, located as near to

the gun as possible, will help eliminate

this moisture.

For Trouble-Free Operation

Moisture in Compressed Air

1. Check compressor for any visible

problems, especially check air filter to

be sure it is clean.

2. Pull ring on safety valve and allow it to

snap back to normal position.

Maintenance

Release all pressure and dis-

connect power before making

any repair.

!

WARNING

Figure 5

Figure 4

Figure 6

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments