RIDGID OF45150 Operator's Manual download pdf (Page 6)

1110

Line Pressure Gauge

Displays the current line pressures. It is

regulated by the regulator knob.

Cut-in/Cut-off Pressure

Specific psi at which a compressor starts

and stops while refilling the air tank.

Glossary of Terms (Continued)

1. Remove the air compressor from the

carton.

2. Place the compressor on a secure,

stationary work surface and look it

over carefully.

Unpacking and Checking Contents

Do not operate unit if damaged

during shipping, handling or

use. Damage may result in

bursting and cause injury or

property damage.

!

WARNING

For your own safety, never

operate unit until all assembly

steps are complete and until

you have read and understood

the entire operator’s manual.

!

WARNING

To reduce the risk of injury, if

any parts are missing, do not

attempt to operate the air com-

pressor until the missing parts

are obtained and installed cor-

rectly.

!

WARNING

1. Check and tighten all bolts, fittings,

etc., before operating compressor.

2. Operate compressor in a ventilated

area so that compressor may be

properly cooled.

3. Compressor should be located where

it can be directly plugged into an out-

let. An extension cord should not be

used with this unit.

4. To avoid loss of power and overheat-

ing, additional air hose must be used

to reach work area instead of exten-

sion cords.

Installation

Getting to Know Your Air Compressor

1. Regulated Outlet Gauge

1. This gauge shows at-a-glance, air

pressure at outlet. Air pressure is

measured in pounds per square inch

(PSI). Most tools have maximum pres-

sure ratings. Never exceed the maxi-

mum pressure rating of the tool you

are using.

2. Be sure this gauge reads ZERO

before changing air tools or discon-

necting hose from outlet.

2. Tank Pressure Gauge

Gauge shows pressure in air receiver

indicating compressor is building pres-

sure properly.

Figure 3

1 Regulated

Outlet Gauge

2 Pressure Tank

Gauge

3 Regulator

Knob

4 Air Filter

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments