RIDGID WD6425 Use and Care Manual download pdf (Page 2)

11

Maintenance

To Remove Power Head Assembly:

1. Grasp the drum latches on both the

right and left side of the power head

assembly. Slowly pull the drum latches

away from the drum. Lift the power

head assembly off the drum. Place the

lid and blower assembly upside down

on the dust drum.

WARNING: For your own safety,

never connect plug to power source

outlet until all assembly steps are

complete and you have read and

understood the safety and operation

instructions. Do not operate Vac

with any parts damaged or missing.

Drum

Latch

Power

Head

Assembly

Hook

Power Head

A

ssembly

!

WARNING: Do not operate

without a filter cage and float, as

they prevent liquid from entering

the impeller and damaging the

!

Removal and Installation

of the Qwik Lock™ Filter

Filter Removal:

1. Hold the filter tabs of the Qwik Lock™

filter in each hand.

2. With one thumb on the Qwik Lock™

stud, which protrudes through the

integrated filter plate, lift up on the

filter tabs while pushing down on the

stud.

3. This action will cause the filter to

release from the filter cage. Slide filter

off cage.

Filter Installation:

1. Carefully slide the Qwik Lock™ filter

over the filter cage and press down on

the outside edge of the filter until the

rubber gasket on the bottom of the

filter seats securely around the base

of the filter cage and against the lid.

2. Align the small center hole in the top

of the filter over the Qwik Lock™ stud

on the filter cage. Press firmly on top

of the filter near the stud to allow the

filter to snap over the ball on the end

of the stud. The filter is now attached.

Qwik Lock™

Stud

Filter

Tabs (2)

Integrated Filter

Plate with Center

Hole

PUSH

DOWN

PULL

UP

Rubber

Gasket at

Bottom of

Filter

(cutaway

view)

Float

Power

Head

Assembly

Filter Cage

Filter Removal and Installation

NOTE: Failure to properly seat the

bottom gasket could result in debris

bypassing the filter.

IMPORTANT: To avoid damage to the

blower wheel and motor, always reinstall

the filter before using the Vac for dry

material pick-up.

SP6932 WD64250 6 Gallon 10/31.qxp_SP6585 WD4050EX 10/31/14 12:00 PM Page 11

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments