RIDGID TS3650 User Manual download pdf (Page 44)

A. Raise blade guard, remove insert,

elevate blade to its highest point.

B. To remove blade, hold arbor wrench

securely, pull arbor nut wrench

towards the front of the table.

C. To tighten arbor nut, hold arbor

wrench securely, push arbor nut

wrench towards the rear of the table.

When installing the blade, make sure the

teeth are pointing toward the front of the

saw and that the blade and collars are

clean, and free from any burrs.

The hollow side of the collar must be

against the blade.

Always tighten the arbor nut securely.

NOTE: When using the dado or molding

head, it is not necessary to install the

outer (loose) blade collar.

D. Lower the blade below the table.

E. To replace insert, place insert into

opening in table and push toward rear

of saw to engage rear spring on insert

and until keyslot in insert will drop

over screw. Tighten screw. Do not

tighten screw to the point where it will

deflect the insert.

44

Getting to Know Your Table Saw (continued)

WARNING: To reduce the risk of

injury from accidental start, turn

switch “OFF” and remove plug

from power source outlet before

removing or installing sawblade.

WARNING: To reduce the risk of

injury from a thrown workpiece,

blade parts, or blade contact,

never operate saw without the

proper insert in place. Use the

table insert when sawing. Use the

proper size dado/molding insert

for dado blades and molding

heads.

WARNING: For your own safety,

turn switch “OFF” and remove

plug from power source outlet

before making any adjustments.

Closed End Arbor

Nut Wrench

Open End

Arbor Nut

Wrench

Tighten

Blade Collar

Arbor Nut

Top Teeth

Pointing To

Front of Saw

Table Insert

Arbor

11. Ind-I-Cut

The plastic disc embedded in the table in

front of the sawblade, is provided for

marking the location of the “sawcut”

(kerf) on the workpiece.

Check disk location: If it is above table

surface, place a piece of hardwood on

top of it and tap it down with a hammer.

Marking the Ind-I-Cut:

A. With blade 90° (square to table) and

miter gauge in left groove, cross cut a

piece of wood holding the wood firmly

against miter gauge.

B. Pull miter gauge back until freshly cut

edge of wood is over disk. Using a

sharp pencil, mark a line on disk at

freshly cut edge of wood.

C. With miter gauge in right hand

groove, follow same procedure and

mark another line on disk.

Marking

Ind-I-Cut

10. Removing and Installing Saw-blade

.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 44

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Comments to this Manuals

No comments