Ridgid SeekTech ST-305 User Manual Page 5
- Page / 141
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Ridge Tool Company
4
Tools For The Professional
TM
SeekTech
®
ST-305
Getting Started
Installing/Changing Batteries
Figure 3: Removing the Battery Cover
NOTE: When replacing batteries, use 6 C cells that are the
same type. Do not mix half used alkalines with brand new
ones.
CAUTION: Remove batteries entirely before shipping.
Operation Time
Typical operation time varies for the ST-305, depending on
factors such as load, environment, and current transmitted.
Other factors that aect the operation time will include
chemistry of the battery (many of the new high performance
batteries, such as the “Duracell ® ULTRA” last 10%-20%
longer than conventional alkaline cells under high demand
applications). Operation at low temperatures will also reduce
battery life.
Batteries often recover after being subjected to high loads.
If time is allowed, batteries may recover enough to oer
additional hours of operation.
Powering Up / Down
Turn the power ON by depressing the Power Key on the
keypad. The current frequency and power level LEDs will
light up. A beep will sound.
Turn the unit OFF by depressing the Power
Key on the
keypad for 2 seconds. Three tones will sound.
Automatic Shut Down
To save energy, the ST-305 will automatically shutdown after
an interval which varies with the power setting:
Low Power 4 hours
Medium Power 2 hours
High Power 1 hour
Battery Check
At start-up, the ST-305 will check available power and will
indicate estimated battery levels by lighting one, two, or
three LEDs in the right hand column (power level) on the
control panel. These levels are only estimates based on a
rapid internal check. A rapid series of beeps will sound if the
battery levels run low in operation.
Sounds of the ST-305 Transmitter
Sounds are associated with specic events or states.
They include:
• Beeps – Beeps when current is owing; rate increases
with current increase.
• Beeps – Turn ON (4 beeps)/OFF (3 beeps).
• Short Double Tone – Inductive Clamp connected.
• Long-Short-Short Tone – Inductive Mode.
• Rapid series of beeps – Low Battery Warning.
The sound may be toggled on or o by pressing the Frequency
and Power buttons simultaneously.
- SeekTech 1
- Operating Instructions 2
- Transmitter Components 3
- Getting Started 5
- Direct-Connect Method 6
- 3. Check the Receiver 7
- Useful Operating Tips 8
- Dual-Frequency Transmission 8
- Inductive Clamp Method 8
- Inductive Mode 9
- Useful Information 10
- Service and Repair 11
- Trouble Shooting Guide 12
- Specications 13
- Standard Equipment 13
- Standard Replacement Parts 13
- Bedienungsanleitung 14
- Komponenten des Transmitters 16
- Bedienfeld 17
- Der Einstieg 18
- Benutzung des ST-305 19
- Leitungstransmitters 19
- Leistungsstufe einstellen 20
- FCC Grenzwerte 20
- Nützliche Bedienungstipps 20
- Dual-Frequenz-Übertragung 21
- Induktionsklammermethode 21
- Induktionsmodus 22
- Hilfreiche Informationen 23
- Service und Reparatur 23
- Leitfaden zur Fehlerbehebung 24
- Technische Daten 25
- Standardausstattung 25
- Standardersatzteile 25
- Instructions d’utilisation 26
- Composants de l’émetteur 28
- Mise en route 30
- Vérication des piles 31
- Méthode de connexion directe 32
- 3. Vériez le récepteur 33
- FCC Limits 33
- Transmission double fréquence 34
- Méthode de la pince inductive 34
- Mode d’induction 35
- Informations utiles 36
- Service et réparation 37
- Guide de dépannage 38
- Caractéristiques 39
- Equipement standard 39
- Pièces de rechange standard 39
- Gebruiksaanwijzing 40
- Zenderonderdelen 42
- Toetsenbord 43
- Aan de slag 44
- Gebruik van de ST-305 45
- 3. Controleer de ontvanger 46
- FCC-limieten 46
- Nuttige gebruikstips 46
- Twee-frequentiestransmissie 47
- Inductieve klem 47
- Inductieve modus 48
- Nuttige informatie 49
- Onderhoud en reparatie 49
- Oplossen van problemen 50
- Specicaties 51
- Standaarduitrusting 51
- Standaardreserveonderdelen 51
- Istruzioni operative 52
- Componenti del trasmettitore 54
- Tastiera 55
- Istruzioni preliminari 56
- 3. Controllare il ricevitore 58
- Limiti FCC 58
- Suggerimenti operativi utili 58
- Metodo del Morsetto induttivo 59
- Modalità induttiva 60
- Informazioni utili 61
- Guida sulla risoluzione dei 62
- Caratteristiche tecniche 63
- Dotazione standard 63
- Pezzi sostitutivi standard 63
- Instrucciones de 64
- Componentes del transmisor 66
- Panel de mandos 67
- Antes de empezar 68
- Método de conexión directa 69
- 3. Inspección del receptor 70
- Límites FCC 70
- Consejos prácticos 71
- Modo inductivo 72
- Información de utilidad 73
- Mantenimiento y reparaciones 74
- Especicaciones 75
- Equipo estándar 75
- Piezas de repuesto estándar 75
- Instruções de 76
- Funcionamento 76
- Componentes do Transmissor 78
- Instalar/Mudar Pilhas 80
- Tempo de Funcionamento 80
- Ligar/Desligar 80
- Vericação das Pilhas 80
- Sons do Transmissor ST-305 80
- Método de Ligação Directa 81
- 3. Vericar o Receptor 82
- Limites FCC 82
- Método do Grampo de Indução 83
- Modo de Indução 84
- Informações úteis 85
- Manutenção e Limpeza 86
- Especicações 87
- Equipamento de Série 87
- Betjeningsvejledning 88
- Senderkomponenter 89
- Klargøring 91
- Betjening af ST-305 92
- 3. Kontroller modtageren 93
- FCC-specikationer 93
- Nyttige tip til betjening 94
- Induktiv klemme-metode 94
- Induktiv funktionstilstand 95
- Nyttige oplysninger 96
- Eftersyn og reparation 97
- Vejledning til fejlnding 98
- Specikationer 99
- Standardudstyr 99
- Standardreservedele 99
- Bruksanvisning 100
- Senderens komponenter 101
- Tastatur 102
- Slik kommer du i gang 103
- Bruke ST-305 linjesender 104
- Nyttige tips om bruken 105
- 3. Kontroller mottakeren 105
- FCC-grenser 105
- Sending på dobbeltfrekvens 106
- Metoden med induktiv klemme 106
- Induktiv modus 106
- Nyttig informasjon 107
- Service og reparasjon 108
- Veiledning for feilsøking 109
- Spesikasjoner 110
- Standardutstyr 110
- Standard reservedeler 110
- Zalecenia 112
- NIEBEZPIECZEŃSTWO 113
- Części składowe nadajnika 114
- Klawiatura 115
- Rozpoczęcie pracy 116
- 3. Sprawdzić odbiornik 119
- Ograniczenia FCC 119
- Metoda opaski indukcyjnej 121
- Tryb indukcyjny 121
- Wskaźnik wysokiego napięcia 122
- Użyteczne informacje 123
- Serwis i naprawy 124
- Dane techniczne 126
- Wyposażenie standardowe 126
- Standardowe części zamienne 126
- Инструкция по 127
- Компоненты передатчика 129
- Кнопочный пульт 130
- Начало работы с прибором 131
- Пользование линейным 132
- 3. Проверить приемник 134
- Полезные рабочие рекомендации 134
- Индукционный режим 135
- Индикатор высокого напряжения 136
- Полезная информация 137
- Сервис и ремонт 138
- Технические характеристики 140
- Стандартные принадлежности 140
- Стандартные сменные детали 140
- Tools For The Professional 141
- RID 890950049-41 141
Related products and manuals for Power tools Ridgid SeekTech ST-305
Power tools Ridgid 540-2 User Manual
(33 pages)
(33 pages)
Power tools Ridgid 1460-E User Manual
(16 pages)
(16 pages)
Power tools Ridgid 248 User Manual
(21 pages)
(21 pages)
Power tools Ridgid NaviTrack II User Manual
(394 pages)
(394 pages)
Power tools Ridgid 535 User Manual
(35 pages)
(35 pages)
Power tools Ridgid RB-3W User Manual
(98 pages)
(98 pages)
Power tools Ridgid Power-Spin User Manual
(186 pages)
(186 pages)
Power tools Ridgid K-1500 G User Manual
(85 pages)
(85 pages)
Power tools Ridgid Seesnake LCD Pak User Manual
(164 pages)
(164 pages)
Power tools Ridgid micro CA-25 User Manual
(236 pages)
(236 pages)
Power tools Ridgid micro EXPLORER User Manual
(449 pages)
(449 pages)
Power tools Ridgid SeeSnake User Manual
(302 pages)
(302 pages)
Power tools Ridgid 918I User Manual
(98 pages)
(98 pages)
Power tools Ridgid micro IR-100 User Manual
(312 pages)
(312 pages)
Power tools Ridgid KJ-3100 User Manual
(454 pages)
(454 pages)
© 2020, manymanuals.com. All rights reserved. | 0.703 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals