RIDGID Dry Cut Saw Instruction Manual download pdf (Page 6)

WARNING: Do not connect the machine to the power source until you have read and understood this

entire instruction manual.

2. Place the machine on a firm, level surface where there is plenty of room for handling and properly supporting

the workpiece.

3. Familiarize yourself with all features and controls as explained in this manual.

4. The machine is shipped with the cutting head (A) Fig. 4, held in the down position by the hold-down chain

(B). Press down on the tool handle to lower the cutting head. Unhook the hold-down chain from the hook

(located just below the tool handle).

5. Slowly release pressure on the tool handle, allowing the cutting head to move to the UP position, as shown

in Fig. 5.

OPERATING INSTRUCTIONS

FOREWORD

Porter-Cable Model 1410 is a 14", “Dry-Cut”, Metal Cutting Saw designed to cut ferrous metals. Cutting

capacities (at 90°) are: 5

/8" Dia. round stock, 4

/4" x 4

/4" square stock, and 3

/4" x 7" rectangular stock (see

following chart), using a 14" (355mm) diameter by

/16" (4.5mm) maximum thickness blade with a 1" (25.4mm)

diameter mounting hole. The saw is equipped with an adjustable fence that can be set for angle cuts between

45° and 90°.

TO START AND STOP MACHINE

CAUTION: Make sure power circuit voltage is the same as shown on the specification plate of the

machine and that switch is OFF before connecting to power circuit.

1. Squeeze trigger switch (A) Fig. 6, to start motor. Release trigger switch to stop motor.

2. A lock button (B) Fig. 6, is provided to lock the switch in the ON position.

TO LOCK the switch ON, squeeze the trigger as far as it will go, push in the lock button and release trigger.

TO UNLOCK the lock button, squeeze trigger allowing lock button to spring out, and release trigger.

SWITCH LOCKOUT

A lock hole through the trigger switch is provided for a padlock (C), Fig. 7, with a

¼4" shackle. A padlock can be

placed through this hole and locked to prevent unauthorized use of the machine. We recommend that a lock be

installed whenever the machine is not in use.

CUTTING CAPACITIES

AT 45 DEGREES AT 90 DEGREES

Workpiece

Configuration

(Cross-Section)

Maximum 4" 3

2" x 3

2"3

2" x 4" 5

8"4

2" x 4

2"3

4" x 7"

Cutting (100mm) (90mm x (90mm x (130mm) (115mm x (95mm x

Capacity 90mm) 100mm) 115mm) 180mm)

Fig. 6 Fig. 7

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

RIDGID Dry Cut Saw Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools RIDGID Dry Cut Saw