RIDGID Dry Cut Saw Instruction Manual Page 1

ESPAÑOL: PAGINA 11FRANÇAISE : PAGE 2314" “Dry-Cut” MetalCutting SawInstructionManualPart No. 896182-009The Model and Serial No. plate is located

10CHIP TRAYThe machine is equipped with a chip tray (N) Fig. 20. This tray collects many of the “chips” produced during thecutting operation. Empty th

The following are trademarks of PORTER-CABLE Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.) (Les marques suivantes sont desm

SAFETY INSTRUCTIONSGROUNDING INSTRUCTIONSWARNING: THIS TOOL SHOULD BEGROUNDED WHILE IN USE TO PROTECT THEOPERATOR FROM ELECTRIC SHOCK. The toolis equi

3IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric tools, basic safety precautions should always be followed to reducethe risk of fire, electr

425. WARNING: SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHERCONSTRUCTION ACTIVITIES contains chemicals known to cause canc

5POWER CONNECTIONSA separate electrical circuit should be used for your tools. Thiscircuit should not be less than #12 wire and should be protectedwit

6WARNING: Do not connect the machine to the power source until you have read and understood thisentire instruction manual.2. Place the machine on a fi

7WORK VISEA work vise is provided to securely clamp the workpieceto the saw base. The stationary jaw can be adjusted forangled cuts of from 0° to 45°

8workpiece orientation). Move clamp locknut (A) Fig. 9A, forward to engage threads on clamp screw (C) Fig. 9A.Tighten vise securely by rotating clamp

9CHANGING THE BLADECAUTION: Disconnect the machine from the power source.1. Use the 2.5mm hex wrench (provided) to remove the three blade cover retain