RIDGID RS1000 Specifications download pdf (Page 65)

65

Troubleshooting

In addition to the proper alignment of your

saw, you must also become familiar with the

following practices in order to expect the

best results.

1. Edge of workpiece which is placed

against fence must be as straight as the long

side of your framing square.

2. Workpiece must be as flat as the front

table board on your saw.

3. There must be no sawdust or other wood

chips between the fence and the front table

board.

4. There must be no sawdust or other wood

chips underneath workpiece or between-

workpiece and fence.

5. Workpiece must be held tightly against

fence and down against the table...this is

especially important when making angle

cuts because the workpiece has a tendency

to move.

6. Always use the correct sawblade for the

job. Always keep it sharp.

7. When making a four sided frame:

a. The two side pieces must be exactly

the same length.

b. The top and bottom pieces must be

exactly the same length.

c. Always place the same edge of the

workpiece against, the fence ... turn the

workpiece end for end for the successive

cuts and mark a pencil line on the table

for gauging the required length.

Deviation from any of the above practices

will have an effect on the accuracy of the

cuts that you make.

This edge of board

against fence for all cuts

Fence

1st Cut

Turn workpiece over end for end...keep same edge

against fence when making successive cuts.

2nd and 4th Cuts

3rd Cut

Scrap

Pencil line for

gauging required length

HAVE YOU FOLLOWED ALL STEPS OF THE

ALIGNMENT PROCEDURE? IF YOU HAVE

NOT FOLLOWED THEM IN THEIR PROPER

SEQUENCE, YOU CANNOT EXPECT ACCU-

RATE CUTTING RESULTS.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 79 80

Comments to this Manuals

No comments