Ridgid R350CHA User Manual download pdf (Page 16)

OPERATION

NAIL STOP TAB

RELEASE

BUTTON

Fig. 11

WARNING:

Disconnect the tool from the air supply before

removing nails or clearing a jammed fastener.

Failure to do so could result in serious personal

injury.

REMOVING NAILS FROM THE TOOL

See Figure 11.

n Disconnect the tool from the air supply.

n �To remove a strip of nails from the tool, press the release

button on the pusher. When released, the pusher will slide

forward.

NOTE: Always keep fingers clear of nail track of magazine

to prevent injury from unintended release of the pusher.

n Press down on the nail stop tab near the end of the

magazine and slide the nails over the tab.

n Remove the nail strip from the tool.

CLEARING A JAMMED FASTENER

See Figure 12.

If a nail or fastener becomes jammed in the tool, disconnect

the air hose and keep the tool pointed away from you while

clearing the jam.

n Disconnect the tool from the air supply.

n �Remove fasteners from the tool.

n Insert a #2 Phillips screwdriver into the driving mecha-

nism.

n Tap the screwdriver gently with a hammer. The inserted

screwdriver should push the driver blade back, freeing

the nail jam.

n Remove the bent nail, using needle-nose pliers if neces-

sary.

n Reconnect the tool to the air supply.

n Reload the tool with nails.

PUSHER

Fig. 12

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Ridgid R350CHA User Manual Page 16