1This Miter Saw Utility Vehicle has been engineered and manufactured to our high standard for dependability, ease of operation and operat
10ASSEMBLYEXTENSION BAR(S) OPERATIONSee Figures 10 - 11.Both extension bars may be adjusted to provide maximum workpiece support. To adjust the extens
11Before You Startn Remove any workpieces, clamps or other accessories.n Make sure miter saw is securely attached to the stand per the instructions in
12ASSEMBLYTRANSPORTING TOOLSee Figure 15.n When hauling the workstand in a vehicle, securely tie it down to prevent movement and possible damage.n Al
13EXPLODED VIEW/REPAIR PARTSMiter Saw Utility Vehicle Model AC99401RIDGID parts are at www.ridgidparts.com1 829859 Rear Roller Extension2 829758-
14NOTES
15WARRANTYProof of purchase must be presented when requesting war-ranty service. Limited to RIDGID® hand held and stationary power tools purchased 2/1
16Customer Service Information:For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant informatio
2n Introduction ...
3RULES FOR SAFE OPERATIONSafe operation of this accessory requires that you read and understand this operator's manual, the operator’s manual for
4SYMBOLSThe purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve yo
5UNPACKINGNOTE: Before beginning assembly, check that all parts are included. If you are missing any part, do not assemble this accessory. Call 1-800
6ASSEMBLYATTACHING THE LOWER FOOTSee Figures 1 d 2.n Place stand assembly “flat” on floor.n Rotate lower foot into upright position aligning holes as
7WORKSTAND SET-UPSee Figures 4 - 5.Before You Startn If a miter saw is already assembled to the stand, make sure that it is securely attached to
8ASSEMBLYMOUNTING MITER SAWSee Figures 6 - 7.WARNING:Failure to unplug the tool could result in accidental starting causing possible serious personal
9ASSEMBLYMOUNTING OTHER BRANDSSee Figure 8.NOTE: Other brands of miter saws (not RIDGID miter saws) will require additional 5/16 in. mounting holes to
Comments to this Manuals