RIDGID SeekTech SR-60 Operator's Manual

10 Watt Pipe andCable Line Transmitter• Français – 19 • Castellano – pág. 39SeekTech®ST-510 ManualWARNING!Read this Operator’s Manualcarefully before

Ridge Tool Company8SeekTech®ST-510 Line Transmitter• Inductive Mode – The transmitter generates a field,which in turn induces a current in the target

Figure 11 – Transmitter In Inductive Clamp Mode5. Clamp the jaws of the inductive clamp around the tar-get conductor. Make sure that the jaws of the c

Ridge Tool Company10SeekTech®ST-510 Line Transmitter2. Press the POWER ON/OFF button on the keypad toturn the transmitter ON. As the power comes on, t

Ridge Tool Company11SeekTech®ST-510 Line Transmittermanufacturers and frequencies, see the ManufacturersFrequency Table on page 16.Consult your receiv

Ridge Tool Company12Figure 22 – Current SelectedWhen a current level is chosen, the transmitter will adjustthe voltage to try and produce the selected

Ridge Tool Company13Auto Back Light The SeekTech is equipped with an automatic LCD back-light. Whenever a key is pressed, the backlight is acti-vated

Ridge Tool Company14Replacement PartsParts are available from your local RIDGID Distributor.A. Direct Connect Lead(48ft./16m) (Cat. #18423)B. Battery

Ridge Tool Company15SeekTech®ST-510 Line TransmitterReceiver will not pick upthe line transmitter’ssignal.LCD appears completelydark, or completely li

Ridge Tool Company16SeekTech®ST-510 Line TransmitterManufacturers Frequency TableDisplayedCompanyAvailable ModelExact Manufacturer Frequencies Frequen

Ridge Tool Company17SeekTech®ST-510 Line TransmitterManufacturers Frequency Table (continued)DisplayedCompanyAvailable ModelExact Manufacturer Frequen

Ridge Tool CompanyiiTable of ContentsRecording Form for Machine Serial Number...

10 Watt Pipe and Cable LineTransmitterSeekTech®ST-510SeekTech®ST-510 Line TransmitterRecord Serial Number below and retain product serial number which

Ridge Tool Company2SeekTech®ST-510 Line TransmitterGeneral Safety RulesWARNINGRead all safety warnings and instructions. Failure to followthe warnings

Ridge Tool Company3SeekTech®ST-510 Line TransmitterEquipment Use and Care• Do not force equipment. Use the correct equipmentfor your application. The

Ridge Tool Company4SeekTech®ST-510 Line Transmitterthe only way to verify its existence, location anddepth.• Avoid traffic. Pay close attention to mov

Ridge Tool Company5SeekTech®ST-510 Line TransmitterTransmitter ComponentsFigure 1 – Top ViewKeypadDisplay ScreenShoulderStrapHandleCoil Cord (48Ft.(16

Installing BatteriesTo install batteries in the ST-510 Line Transmitter, turnthe knob on the battery holder counter clockwise until theholder is loose

power source is fully isolated from ground and powermains. If the transmitter is not isolated, the transmitter isnot protected from connection to ener