Ridgid SR-60 User Manual download pdf (Page 47)

Ridge Tool Company  Elyria, Ohio  U.S.A www.seektech.com 45

SeekTech SR-60

Trouble Shooting Guide

PROBLEM PROBABLE FAULT LOCATION

SR-60 locks up during

use.

Power the unit off, and then back on. Remove the batteries if the unit will not switch off.

If batteries are low, replace them.

SR-60 will not pick up

the signal.

Check that the correct mode and frequency is set. Examine circuit for possible

improvements. Relocate transmitter, change grounding, frequency, etc.; or modify

Signal Focus Control settings (page

32).

This indicates that the SR-60 is not picking up the signal or there is interference.

Make sure that the transmitter is well connected and grounded. Point the SR-60 at

either lead to be sure that there is a complete circuit.

Try a higher frequency, or connecting to a different point in the line, or switching to

inductive mode.

Try to determine the source of any noise and eliminate it. (Bonded grounding, etc.)

While tracing, lines

are “jumping” all over

the screen in the

mapping display.

Check SR-60 batteries are fresh and fully charged

Check the batteries in the Sonde to see that they are working.

Sonde may be too far away; try starting with it closer in if possible, or do an area search.

While locating a

Sonde, lines are

“jumping” all over the

screen.

Verify signal by placing lower antenna close to Sonde. Note – Sondes have difficulty

emitting signals through cast iron and ductile iron lines.

Distance between

Sonde and either Pole

is not equal.

Sonde may be tilted or there may be a cast-iron-to-plastic transition.

Unit acts erratic, won’t

power down.

Batteries may be low. Replace with fresh batteries and power on.

Power the unit off and then back on. Display appears

completely dark or

completely light when

it is switched on.

Adjust the LCD screen contrast.

There is no sound. Adjust the sound level in the sound menu. Verify Proximity Signal is greater than zero.

SR-60 will not power

on.

Check orientation of batteries.

Check that the batteries are charged.

Check to see that the battery contacts are OK.

Unit may have blown a fuse. (Factory service is required.)

1 2 ... 42 43 44 45 46 47 48 49 50 51

Comments to this Manuals

No comments

Ridgid SR-60 User Manual Page 47

Comments to this Manuals

Related products and manuals for Sports and recreation Ridgid SR-60