RIDGID 1822-I Operator's Manual download pdf (Page 34)

NaviTrack

PROBLEM PROBABLE FAULT LOCATION

The NaviTrack II locks up

during use.

NaviTrack II will not pick

up the signal.

While tracing, lines are

“jumping” all over the

screen in the mapping

display.

While locating a Sonde,

lines are “jumping” all

over the screen.

Distance between Sonde

and Poles is not equal.

Unit acts erratic, won’t

power down.

Display appears

completely dark, or

completely light when

it is turned ON.

There is no sound.

NaviTrack II will not turn

ON.

When using 93kHz

frequency the detector

does not receive

a signal.

Chart 1 Troubleshooting

Turn the unit OFF, and then back ON. Remove the batteries if the unit will not turn off. If batteries are

low, replace them.

Check that the correct mode and frequency is set. Examine circuit for possible improvements. Relocate

transmitter, change grounding, frequency, etc.

This indicates that the NaviTrack II is not picking up the signal or there is interference.

Make sure that the transmitter is well connected and grounded. Point the NaviTrack II at either lead to be

sure that there is a complete circuit.

Try a higher frequency, or connecting to a different point in the line, or switching to inductive mode.

Try to determine the source of any noise and eliminate it (Bonded, grounding, etc.).

Check the batteries in the Sonde to see that they are working.

Sonde may be too far away; try starting with it closer in if possible, or do an area search.

Verify signal by placing lower antenna close to Sonde. NOTE – Sondes have difficulty emitting signals

through cast iron and ductile iron lines.

Sonde may be tilted or there may be a cast iron to plastic transition.

Batteries may be low. Replace with fresh batteries and turn ON.

Power the unit OFF and then back ON.

Adjust the LCD screen contrast.

Adjust the sound level in the sound menu. Verify Proximity Signal is greater than zero.

Check orientation of batteries.

Check that the batteries are charged.

Check to see that the battery contacts are OK.

Unit may have blown a fuse (Factory service is required).

Try setting the receiver to the 93-B frequency as described on

page 17

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

1 2 ... 29 30 31 32 33 34

Comments to this Manuals

No comments

RIDGID 1822-I Operator's Manual Page 34

Comments to this Manuals

Related products and manuals for Sewing machines RIDGID 1822-I