RIDGID R9614 Use and Care Manual download pdf (Page 31)

7 - English

ASSEMBLY

OPERATION

WARNING:

Do not allow familiarity with products to make you

careless. Remember that a careless fraction of a

second is sufficient to inflict severe injury.

WARNING:

Always wear eye protection with side shields

marked to comply with ANSI Z87.1 along with

hearing protection. Failure to do so could result

in objects being thrown into your eyes and other

possible serious injuries.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product.

The use of attachments or accessories not

recommended can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

Driving screws, lag bolts

Tightening nuts and bolts

Removing screws, nuts, and bolts

This product will accept RIDGID 18 V lithium-ion battery

packs and RIDGID 18 V nickel-cadmium battery packs.

For complete charging instructions, refer to the Operator’s

Manual for the battery packs and chargers for your models.

BATTERY PROTECTION FEATURES

RIDGID 18 V lithium-ion batteries are designed with features

that protect the lithium-ion cells and maximize battery life.

Under some operating conditions, these built-in features

may cause the battery and the tool it is powering to act

differently from nickel-cadmium batteries.

During some applications, the battery electronics may signal

the battery to shut down, and cause the tool to stop running.

To reset the battery and tool, release the trigger and resume

normal operation.

NOTE: To prevent further shut down of the battery, avoid

forcing the tool. Switching to a lower speed will also prevent

shut down.

If releasing the trigger does not reset the battery and tool,

the battery pack is depleted. If depleted, the battery pack

will begin charging when placed on the lithium-ion charger.

LED GRIP LIGHT

See Figure 1, page 11.

The LED light switch is located on the handle of the tool.

The LED light, located on the front of the tool base, illumi-

nates when either the switch trigger or grip light switch is

depressed.

If the tool is not in use, the time-out feature will cause the

light to start fading and then shut off.

The LED light illuminates only when there is a charged bat-

tery pack in the tool.

WARNING:

If any parts are damaged or missing do not operate

this product until the parts are replaced. Use of

this product with damaged or missing parts could

result in serious personal injury.

WARNING:

Do not attempt to modify this product or create

accessories not recommended for use with this

product. Any such alteration or modification is

misuse and could result in a hazardous condition

leading to possible serious personal injury.

WARNING:

To prevent accidental starting that could cause

serious personal injury, always remove the battery

pack from the product when assembling parts.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 57 58

Comments to this Manuals

No comments

RIDGID R9614 Use and Care Manual Page 31

Comments to this Manuals

Related products and manuals for Power impact wrenches RIDGID R9614