RIDGID R4511 Operator's Manual download pdf (Page 8)

Shark face decal application

The decals come in two parts. The mouth and the eye. If you are looking at the shark

from the front, the decals go in on the left side. We recommend that you use Windex

(any glass cleaner) and a soft cotton cloth like a T-shirt to clean the guard first. It may

help to look at a photo like this one below. Remember, you are looking at the reverse

side in this image. This was done so that you wouldn't have to handle the decal when

moving the shark. It also gives is a nice appearance from the outside of the lexan.

These are water slide decals. Below are the instructions for applying these.

Place decal into a cup of clean water for 45-60 seconds and remove when the thin

decal film begins to slip along backing. (Discard backing material after the decal has

been removed)

Apply decal to clean surface. Here is a link to a PDF file that you can print out. It will

help you get the proper placement for these. Just print page two. Lay the guard down

on the image and then you will be able to place the decals on the inside where they

should go. Once you have them in position, gently pat the decals dry with a soft cloth

or towel going from one side to the other. Insure there are no air bubbles under the

decals. They should dry in a matter of hours. Decal placement file.

1 2 3 4 5 6 7 8 9

No comments

RIDGID R4511 Operator's Manual Page 8