RIDGID WD1451 Installation Guide download pdf (Page 6)

If any parts are missing or damaged

contact Customer Service.

Do not assemble until you have all the

parts.

1. Insert the front and rear caster feet into

the bottom of drum as shown. Light

taps with a mallet or hammer may be

needed to fully seat both caster feet.

2.

Install (4) #10 x 1-3/4” screws into

matching holes on both front and rear

caster feet, securing them to the

bottom of the drum. Tighten screws

until just snug. Do not over tighten as

this may tend to deform the caster feet.

3. Insert the caster stem into each of the

caster feet, as shown.

4. Push on the caster until the ball on the

caster stem is inserted all the way into

the socket. You will be able to hear the

ball snap into the socket and the caster

will swivel easily when positioning is

correct.

Drum/Caster Foot Assembly

Rear

Caster

Foot

Drain

Front

Caster

Foot

Drum

Front

Caster

Foot

Drain

#10 x 1-3/4"

Screw (4)

Rear

Caster

Foot

Socket

Caster Stem

Caster Ball

SP6735 RIDGID 5/31/11 2:13 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comments to this Manuals

No comments