RIDGID OL40135SS Use and Care Manual download pdf (Page 8)

8 – English

EXTENSION CORDS

Use only 3-wire extension cords that have 3-prong ground-

ing plugs and 3-pole receptacles that accept the product’s

plug. When using a power tool at a considerable distance

from the power source, use an extension cord heavy enough

to carry the current that the tool will draw. An undersized

extension cord will cause a drop in line voltage, resulting in

a loss of power and causing the motor to overheat. Use the

chart provided below to determine the minimum wire size

required in an extension cord. Only round jacketed cords

listed by Underwriter’s Laboratories (UL) should be used.

**Ampere rating (on product data plate)

0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0

Cord Length Wire Size (A.W.G.)

25' 16 16 16 16 14 14

50' 16 16 16 14 14 12

100' 16 16 14 12 10 —

**Used on 12 gauge - 20 amp circuit.

NOTE: AWG = American Wire Gauge

When working with the product outdoors, use an extension

cord that is designed for outside use. This is indicated by

the letters “W-A” or “W” on the cord’s jacket.

Before using an extension cord, inspect it for loose or

exposed wires and cut or worn insulation.

WARNING:

Keep the extension cord clear of the working area.

Position the cord so that it will not get caught on

lumber, tools, or other obstructions while you are

working with a power tool. Failure to do so can

result in serious personal injury.

WARNING:

Check extension cords before each use. If

damaged replace immediately. Never use the

product with a damaged cord since touching

the damaged area could cause electrical shock

resulting in serious injury.

ELECTRICAL CONNECTION

This product is powered by a precision-built electric motor.

It should be connected to a power supply that is 120 V, AC

only (normal household current), 60 Hz. Do not operate

this product on direct current (DC). A substantial voltage

drop will cause a loss of power and the motor will overheat.

If the product does not operate when plugged into an outlet,

double check the power supply.

GROUNDING INSTRUCTIONS

This product must be grounded. In the event of a malfunction

or breakdown, grounding provides a path of least resistance

for electric current to reduce the risk of electric shock.

This product is equipped with an electric cord having an

equipment-grounding conductor and a grounding plug. The

plug must be plugged into a matching outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

Do not modify the plug provided. If it will not fit the outlet,

have the proper outlet installed by a qualified electrician.

WARNING:

Improper installation of the grounding plug is liable

to result in a risk of electric shock. When repair or

replacement of the cord is required, do not connect

the grounding wire to either flat blade terminal.

The wire with insulation having an outer surface

that is green with or without yellow stripes is the

grounding wire.

Check with a qualified electrician or service personnel if the

grounding instructions are not completely understood, or if

in doubt as to whether the product is properly grounded.

Repair or replace a damaged or worn cord immediately.

This product is for use on a nominal 120 V circuit and has

a grounding plug similar to the plug illustrated in figure 2,

page 17. Only connect the product to an outlet having the

same configuration as the plug. Do not use an adaptor with

this product.

ELECTRICAL

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments

RIDGID OL40135SS Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Air compressors RIDGID OL40135SS